This page contains pinouts and technical information for various ECYPH LLC cables.
Use the links below to jump directly to specific cables.
PDCT5-H9 is powered by the device that the Palm is plugged into. It is powered from both the DTR pin and the CTS/RTS pins. The CTS and RTS pins from the D-sub end are connected together. This product is electrically the same as a Serial Hotsync Cradle. 9 Pin Female Dsub Connector # Signal 1 n.c. 2 TX (Palm transmit) 3 RX (Palm receive) 4 DTR (DTR from PC - power, if available, is drawn from this pin) 5 GND 6 n.c. 7 RTS (RTS from PC - power, if available, is drawn from this pin) 8 CTS (CTS pin - connected to pin 7) 9 n.c.
PDCT5-M9-6 and PLPT5-M9-6 are powered from the Palm. PDCT5-M9-6 6" cable, True RS232 PLPT5-M9-6 6" cable, Low Power, Quasi-RS232 9 Pin Male Dsub Connector # Signal 1 n.c. 2 RX (Palm receive) 3 TX (Palm transmit) 4 DTR (asserts continuously whenever the cable is plugged into the Palm) 5 GND 6 n.c. 7 RTS (same as pin 4) 8 n.c. 9 n.c.
PDCT5-F5W68HT is powered from the Palm. 9 Pin Female Dsub Connector # Signal 1 n.c. 2 TX (Palm transmit) 3 RX (Palm receive) 4 n.c. 5 GND 6 DSR (asserts continuously whenever the cable is plugged into the Palm) 7 n.c. 8 CTS (same as pin 6) 9 n.c.
PDC65-M9-47HT-6 is Auto-Detecting and is True RS232. The cable length is 6". 9 Pin Male Dsub Connector # Signal 1 n.c. 2 RX (Palm receive) 3 TX (Palm transmit) 4 DTR (asserts continuously whenever the cable is plugged into the Palm) 5 GND 6 n.c. 7 RTS (same as pin 4) 8 n.c. 9 n.c.